International Journal of Engineering، جلد ۳۳، شماره ۵، صفحات ۹۰۶-۹۱۵

عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله

عنوان انگلیسی Investigation on Formability of Tailor-Welded Blanks in Incremental Forming
چکیده انگلیسی مقاله Steel laser tailor-welded blanks (TWBs) are produced by end-to-end joining of base sheets using different welding methods. In this article, the formability of laser TWBs of St12 and St14 with thicknesses of 1 mm and 1.5 in single point incremental forming process were experimentally and numerically investigated. First, the forming limit wall angle was experimentally determined for each of the base sheets. Then, SPIF of TWBs samples was carried out at the thinner sheet wall angle; 67°. For numerical investigation, the mechanical properties of the weld zone were obtained. For one combination of TWBs, the finite element (FE) simulation of incremental forming was performed by the use of ABAQUS/Explicit FE software. The simulation process was validated by comparing the results with those of experiments. Then, the effect of SPIF on thickness, stress and strain distribution of other combinations of TWBs was numerically investigated. The results showed that using the FE model, the SPIF of TWBs without performing high cost experimental tests can be properly investigated. Also, the results revealed that in steel laser TWBs with different thicknesses, the maximum and minimum principal strains are concentrated at the corners and the walls of the thinner sheet of TWBs, respectively. Hence, the maximum amount of effective strain is concentrated at the thinner side of TWBs corners and the weld zone of the two blanks. For the same reason, rupture is observed at these regions.
کلیدواژه‌های انگلیسی مقاله

نویسندگان مقاله R. Panahi Leavoli |
Advanced Material Forming Research Center, Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran

H. Gorji |
Advanced Material Forming Research Center, Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran

M. Bakhshi-Jooybari |
Advanced Material Forming Research Center, Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran

M. J. Mirnia |
Advanced Material Forming Research Center, Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran


نشانی اینترنتی http://www.ije.ir/article_107063_40b713e75c36728eb833fb043829a084.pdf
فایل مقاله اشکال در دسترسی به فایل - ./files/site1/rds_journals/409/article-409-2399763.pdf
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات