| چکیده انگلیسی مقاله |
Introduction and Objective Today, the destruction of natural resources is one of the most important and serious challenges facing development programs. Soil erosion is among the processes that directly and indirectly threaten our country's soil and water resources. Water erosion appears on the earth in different forms, one of the advanced forms of which is the gulies. Gully erosion is one of the important processes of soil destruction, which in different climates causes significant soil losses and the production of large amounts of sediment. The purpose of the present research is to investigate the morphological characteristics of the gullies of Khuzestan province and the role of its influencing factors in the expansion of the gully areas. Materials and Methods First, by collecting available data and comparing it to satellite image and other data, the province's gullies have been defined. The first field visit focused on verifying the integrity of these areas and correcting the gullies boundaries. The total area of Khuzestan province approximately is 64000 km2 in the dry desert climate, and more than 33,862 ha of it is under the influence of gully erosion. The hot semi-arid climate also covers approximately 12,1% of the province and 16,116 ha have experienced gullies erosion. After determining the area of gullies and dividing the areas above and below 500 ha, due to the difference in appearance, topography, and vegetation, 2 and 1 representative areas were selected from the hot-dry desert and hot-semi-arid climates, respectively, and 2 replicates were selected from each representative. Longitudinal and cross-sectional profiles of representative and replicated gullies were drawn and after soil sampling, all morphological features of the gullies were measured. Results and Discussion According to the results, most of the gullies of the province have been created in the plains with a low slope with deep soil and loamy sand texture, silt or silt loam with pasture, and sometimes agricultural land and U-shaped cross-section. Darkhazine and Sharif gullies, with 1260 and 912 cm, and Darkhazine gullies with 420 cm value have the maximum width of top, bottom and depth in the cross-section of 75%. Also, the gullies of Choghazanbil, Darkhazine and Choghazanbil with values of 30 cm have the lowest depth, top and bottom width in the cross-section area of 75%. The overall profile is scratched, and in terms of depth class, they are in the category of medium-deep gullies with a vertical top. Conclusion and Suggestions Intrinsic characteristics of soil, formation and geological type, climate, intensity of rainfall as natural factors, and destruction of vegetation, land use change and the lack of proper management, unprincipled road and bridge construction operations, construction and installation of oil facilities and electricity bars as human factors have played a role in the process of gully expansion. However, the diversity and change of the number and degree of influence of different factors from one point to another and the difference in their participation in the formation and expansion of the gully are based on the environmental conditions of the land. These conditions require that more research be carried out to identify as many factors as possible in the phenomenon of gully erosion and their participation in the formation and expansion of this phenomenon in different places and with different environmental conditions. |