این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
یکشنبه 27 مهر 1404
Iranian Journal of Chemistry and Chemical Engineering
، جلد ۴۰، شماره ۶، صفحات ۱۸۹۳-۱۹۰۸
عنوان فارسی
چکیده فارسی مقاله
کلیدواژههای فارسی مقاله
عنوان انگلیسی
Theoretical Investigation of Entropy Generation in Axisymmetric Stagnation Point Flow of Nanofluid Impinging on the Cylinder Axes with Constant Wall Heat Flux and Uniform Transpiration
چکیده انگلیسی مقاله
Dimensionless temperature, Nusselt number, and entropy generation in stagnation flow of incompressible nanofluid impinging on the infinite cylinder with uniform suction and blowing have been presented in this study. The initial stream rate of the steady free stream is k
. A similar solution of Navier-Stokes and energy equations has been presented. These equations are simplified by implementing appropriate transformations introduced in this research. The governing equations are solved where the heat flux at the cylinder’s wall is constant. All these solutions are acceptable for Reynolds numbers
of 0.1-1000, various dimensionless surface diffusion
, and specific volume fractions of nanoparticles where a is the cylinder radius and
is the kinematic viscosity of the base fluid. The results show that for all Reynolds numbers, diffusion depth of radial and axial components of velocity field and wall shear stress increases as a result of the decline in nanoparticles volume fraction and growth in surface diffusion. Moreover, an increase in nanoparticle volume fraction and surface suction raises
the heat transfer coefficient
and Nusselt number. Also, the greatest amount of entropy generation is calculated.
کلیدواژههای انگلیسی مقاله
Nano fluid,stagnation flow,Similarity solution,volume fraction,Entropy generation
نویسندگان مقاله
Reza Zahmatkesh |
Department of Mechanical Engineering, Shahrood Branch, Islamic Azad University, Shahrood, I.R. IRAN
Hamid Mohammadiun |
Department of Mechanical Engineering, Shahrood Branch, Islamic Azad University, Shahrood, I.R. IRAN
Mohammad Mohammadiun |
Department of Mechanical Engineering, Shahrood Branch, Islamic Azad University, Shahrood, I.R. IRAN
Mohammad Hosein Dibaei Bonab |
Department of Mechanical Engineering, Shahrood Branch, Islamic Azad University, Shahrood, I.R. IRAN
Meisam Sadi |
Department of Mechanical Engineering, Shahrood Branch, Islamic Azad University, Shahrood, I.R. IRAN
نشانی اینترنتی
https://ijcce.ac.ir/article_43346_30047c24a06840156fb1c90c0697c06d.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات