این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
دوشنبه 3 آذر 1404
International Journal of Engineering
، جلد ۳۳، شماره ۹، صفحات ۱۷۵۹-۱۷۶۵
عنوان فارسی
چکیده فارسی مقاله
کلیدواژههای فارسی مقاله
عنوان انگلیسی
Investigation on Mechanical and Electrical Properties of Cu-Ti Nanocomposite Produced by Mechanical Alloying
چکیده انگلیسی مقاله
In this paper, Cu-Ti nanocomposite synthesized via ball milling of copper-titanium powders in 1, 3, and 6 of weight percentage compounds. The vial speed was 350 rpm and ball to powder weight ratio kept at 15:1 under Argon atmosphere, and the time of milling was 90 h. Obtained powders were studied by scanning electron microscopy (SEM), X-ray diffraction (XRD), and dynamic light scattering (DLS). Crystallite size, lattice strain, and lattice constant were calculated by Rietveld refinement with Maud software. The results show a decrease in the crystallite size, and an increase in the internal strain and lattice parameter. Furthermore, the lattice parameter grew by increasing the percentage of titanium. Then, the powders compressed by the cold press and annealed at 650˚C, and finally, their micro-hardness and electrical resistance were measured. These analyses show that via increasing the proportion of titanium, Cu-6wt%Ti with 312 Vickers had the highest micro-hardness; due to the increasing the work hardening. Moreover, the results of the electrical resistance illustrate through increasing the amount of alloying material, the electrical resistance grew which the highest electrical conductivity was Cu-1wt%Ti with 0.36 Ω.
کلیدواژههای انگلیسی مقاله
Copper-Titanium alloys,mechanical alloying,Electrical resistance,Mechanical properties
نویسندگان مقاله
R. M. Babaheydari |
Department of Material Science and Engineering, Shahid Bahonar University of Kerman, Iran
S. O. Mirabootalebi |
Department of Material Science and Engineering, Shahid Bahonar University of Kerman, Iran
G. H. Akbari |
Department of Material Science and Engineering, Shahid Bahonar University of Kerman, Iran
نشانی اینترنتی
https://www.ije.ir/article_113058_467dd5493805072d31b55a44251c4be7.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات