این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Iranian Journal of Materials Forming، جلد ۱۰، شماره ۲، صفحات ۲۲-۳۴
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Effect of Severe Surface Plastic Deformation on Tribological Properties of CoCrWNi Super Alloys
چکیده انگلیسی مقاله The effect of severe surface plastic deformation on the microstructure and tribological properties of CoCrWNi super alloy L605 was investigated. The surface of the annealed alloy was frictionally processed by a tungsten carbide tool with a tip radius of 5 mm under different sliding speeds of 500, 800, 1100, 1400, 1700, and 2000 mm/min for 2, 5, 10, 20, and 30 passes. Based on the results, applying friction hardening (FH) promoted the formation of the e-HCP (martensite) phase in the surface structure of the g-FCC alloy up to a depth of about 500 mm. The maximum surface hardness was observed at the sliding speed of 1700 mm/min and 30 passes, where the surface hardness increased by almost 100% (from about 320 HV to more than 635 HV). Pin-on-disk wear tests were carried out at room temperature, under applied pressures of 0.25, 0.5, and 1 MPa, for a sliding distance of 1000 m. According to the results, under low applied pressures, i.e. 0.25 MPa, the maximum wear resistance was observed in the sample FH-processed for 30 passes at 1700 mm/min. However, due to the formation of lateral microcracks on the surface of samples processed by high number of FH passes, under the applied pressure of 1 MPa, the lowest wear was observed in the 5-pass processed sample (1700 mm/min). The wear rate and average friction coefficient (AFC) of this sample were about 45% and 30% lower than those of the base (annealed) sample, respectively.
کلیدواژه‌های انگلیسی مقاله L605, friction hardening, hardness, sliding wear, tribology
نویسندگان مقاله R. Nemati |
Department of Metallurgy and Materials Science, Imam Khomeini International University, Qazvin, Iran

R. Taghiabadi |
Department of Metallurgy and Materials Science, Imam Khomeini International University, Qazvin, Iran

M. Saghafi Yazdi |
Department of Metallurgy and Materials Science, Imam Khomeini International University, Qazvin, Iran

S. Amini |
Faculty of Mechanical Engineering, Department of Mechanical Engineering, Manufacturing and Production, University of Kashan, Iran

نشانی اینترنتی https://ijmf.shirazu.ac.ir/article_7082_517fa4f14642902a6fd494ecf03ff739.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات