این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Iranian Journal of Materials Forming، جلد ۱۰، شماره ۲، صفحات ۴-۱۱
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Integral Hydro-Bulge Forming of Spherical Vessels: A Numerical and Experimental Study
چکیده انگلیسی مقاله The integral hydro-bulge forming (IHBF) process, also called shell hydroforming, is a die-less forming technique used to manufacture hollow parts from preforms made of sheet blanks cut and welded together. In this study, integral hydro-bulging of spherical vessels was investigated both numerically and experimentally. Numerical simulations were performed using Abaqus commercial software, and the numerical results were validated via comparison with those obtained from the experiments. The thickness distribution along the equatorial and meridian paths, sphericity of the formed vessel, and critical fluid pressure at which instability occurs were studied, and the effect of the number of lateral petals was investigated. For this study, an St12 steel sheet with a thickness of 0.8 mm was used to make a spherical shell with 12 lateral petals and a diameter of 400 mm. The results showed that the use of preforms with more lateral petals leads to a more uniform thickness distribution and shape accuracy in the formation of spherical vessels. Furthermore, by increasing the number of petals from 8 to 16, the thickness decreased by 4.2%. The maximum thickness reduction occurs in the 8-petal state, and the least thickness reduction occurs in the 12-petal state. The results show that the increase in the number of lateral petals leads to the increase in the critical fluid pressure. By doubling the number of lateral petals, fracture pressure increased by 74% consequently.
کلیدواژه‌های انگلیسی مقاله Integral hydro-bulge forming, Shell hydroforming, Lateral petals, Thickness distribution, Critical fluid pressure
نویسندگان مقاله H. Deilami Azodi |
Department of Mechanical Engineering, Arak University of Technology, Arak, Iran

J. Rezaei |
Department of Mechanical Engineering, Arak University of Technology, Arak, Iran

A. Zeinolabedin-Beygi |
Department of Mechanical Engineering, Tarbiat Modares University, Tehran, Iran

H. Badparva |
Department of Mechanical Engineering, Khajeh Nasir al-Din Tusi University of Technology, Tehran, Iran

نشانی اینترنتی https://ijmf.shirazu.ac.ir/article_7032_d19d8d1d477d80bce5fe2f3066ba4d89.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات