این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Computational and Applied Research in Mechanical Engineering - JCARME، جلد ۲، شماره ۲، صفحات ۳۳-۴۳
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Influence of varying timing angle on performance of an SI engine: An experimental and numerical study
چکیده انگلیسی مقاله Engine performance depends on two main factors of engine speed and ignition time. Ignition timing can affect engine life, fuel economy and engine power. In this paper, to study engine performance of Peugeot 206 TU3A with comparison ratio of 10.5:1 and displacement of 1361CC in MATLAB software, a two-zone burned/unburned model with the fuel burning rate described by aWiebe function was used for modeling in-cylinder combustion. For studying this issue, thermodynamic models such as Woshni, Isentropic, etc. were used. Then, the experiments were carried out to validate the calculated data. The objective of the present work was to examine effect of ignition timing on the performance of an SI engine. For achieving this goal, at the speed of 3400 rpm, ignition timing was changed in the range of 41 degrees before the top dead centre to 10 degrees after TDC. By changing the ignition timing, the results of some characteristics such as power, torque, indicatory pressure, exhaust emission and efficiency were obtained and compared. The results demonstrated that optimal power and torque and the maximum efficiency were achieved at 31 degrees before the top dead centre and engine performance was improved by changing timing angle. It was also indicated that the maximum thermal efficiency could be accomplished while peak pressure occurred between 5 and 15 degrees of ATDC. The amounts of O2, CO2 and CO were almost constant but HC increased with increase of ignition timing.
کلیدواژه‌های انگلیسی مقاله
نویسندگان مقاله امیرحسین کاکایی | a h
department of automotive engineering, iran university of science and technology, iran
سازمان اصلی تایید شده: دانشگاه علم و صنعت ایران (Iran university of science and technology)

j زارعی |
engineering center for technical drawing, sharif university of technology, iran
سازمان اصلی تایید شده: دانشگاه صنعتی شریف (Sharif university of technology)

نشانی اینترنتی http://jcarme.srttu.edu/article_51_e6cfbe459a574674bdab2e1bbd575eac.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات