این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
International Journal of Iron and Steel Society of Iran، جلد ۴، شماره ۱، صفحات ۵۰-۵۴
عنوان فارسی An Investigation on Mold Powders Properties Consumed in Iran
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی An Investigation on Mold Powders Properties Consumed in Iran
چکیده انگلیسی مقاله    This paper describes the work done between IUST and two Iranian steelworks to evaluate and review the performance of mould fluxes in current use for continuous casting. Calculations have been performed to compare actual values of powder consumption, viscosity and break temperature of the fluxes in current use with required values derived from published empirical rules for casting conditions. It has been found that there is, in general, poor agreement between actual and required values. The required viscosities of mould fluxes consumed in MC grades are 2.2 and 1.9 dPas while the measured values are 1.5 and 1.1 dPas, respectively indicating higher values. This situation is reverse in LC grades, and actual viscosities are lower than the measured values based on empirical rules. There is also a disagreement between the carbon content and break temperature of the current fluxes and required values resulting in the defects in produced slabs. These differences are more critical in MC grades.
This does not necessarily mean that fluxes are not working well but does imply that a review of mould flux performance is needed before the planned increases in production are implemented.
One steel company experienced problems with overflows of steel (bleeds) and with depressions in the surface of the slab. Possible reasons for the formation of these defects are proposed.
کلیدواژه‌های انگلیسی مقاله Steel, Continuous-Casting, Mould Flux Properties
نویسندگان مقاله a اظهری |
department of materials engineering, iranian university of science and technology iust , tehran, iran

f گلستانی فرد | golestani fard
department of materials engineering, iranian university of science and technology iust , tehran, iran

kc میلز |
department of materials, imperial college, london, uk

f پورداود |
technical department, pishgam company

m راستی |
research and development, khouzestan steel company, ahwaz, iran

j ایزدی |
research and development, mobarakeh steel company, isfahan, iran

نشانی اینترنتی http://journal.issiran.com/article_4829_44998de43e368cdf359d141745c77694.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده fa
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات