Journal of Ultrafine Grained and Nanostructured Materials، جلد ۵۷، شماره ۱، صفحات ۹-۱۸
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Non-Uniform Simple Shear Extrusion (NUSSE) Technique as a novel sever plastic deformation technique
چکیده انگلیسی مقاله In this research, a new technique for severe plastic deformation (SPD) was proposed, entitled as non-uniform simple shear extrusion (NUSSE). The larger strains can be obtained in the non-uniform simple shear extrusion (NUSSE) method without repetition of the process. But, in pure shear extrusion (PSE) and simple shear extrusion (SSE) processes, to achieve larger strains, it is necessary to repeat the processes. In this study, the technique was investigated experimentally and numerically using ABAQUS software. The maximum plastic strain, inhomogeneity in deformation, filling fraction and micro-hardness parameters were researched after NUSSE process. Also, the obtained results were compared to the SSE and PSE processes. After this technique, due to the specific design of deformation channel, filling fraction was increased by about 44.92% and 41.84% in comparison with SSE and PSE processes, respectively. Also, the micro-hardness was significantly increased compared to annealing process.
کلیدواژه‌های انگلیسی مقاله Sever plastic deformation,Non-Uniform Simple Shear Extrusion,Filling fraction,Inhomogeneity in deformation,Micro-hardness
نویسندگان مقاله Ali Izi |
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran

Mohammad Honarpisheh |
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran

Farshid Ahmadi |
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran

نشانی اینترنتی https://jufgnsm.ut.ac.ir/article_97668_fda51ba83b2d7f451d75a73aae05d335.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات