این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
International Journal of Engineering، جلد ۳۵، شماره ۴، صفحات ۶۷۵-۶۸۴
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Influence of Multiple Repairs on the Quality of Duplex Welded Joints
چکیده انگلیسی مقاله Duplex stainless steels (DSSs) find increasing use as a substitution to austenitic stainless steels in oil, gas and petrochemical industries, particularly in aggressive environments. Duplex stainless steels with appropriate controlled ferrite-austenite balance combine the attractive properties of excellent strength, general corrosion performance and adequate weldability. All the welding joints subjected to the regulation must be controlled before commissioning the pipeline and even before hydrostatic tests; all not acceptable defects detected with non-destructive testing (NDT) control methods must be eliminated. In some cases, several successive repairs are often preferred to part replacement in the pipeline due to lack of experience of the welder performing the repairs or lack of expertise of the controller ensuring the application of the welding procedure. The purpose of this work is to study the influence of repairs on the same welding joint on the microstructure and the mechanical properties of the heat-affected zone in duplex stainless steel with 22% chromium welding joints. For this purpose, a cylindrical specimen is prepared, on which the various repairs are carried out. Then, an NDT control and the main mechanical and micrographic tests are conducted. The results obtained after four repairs revealed that the multiple repairs made to the same joint did not affect the quality of the welding joints.
کلیدواژه‌های انگلیسی مقاله Duplex stainless steel,pipelines,Successive repair,Welding defect
نویسندگان مقاله A. Bennabi |
Laboratory of Composites Structures and Innovative Materials (LCSIM), Mechanical Engineering Faculty, USTO-MB Oran, El- M’Naouar, Oran, Algeria

A. Adjeloua |
Laboratory of Composites Structures and Innovative Materials (LCSIM), Mechanical Engineering Faculty, USTO-MB Oran, El- M’Naouar, Oran, Algeria

H. Ameur |
Department of Technology, University Centre of Naama, Naama, Algeria

N. Boualem |
Laboratory of Composites Structures and Innovative Materials (LCSIM), Mechanical Engineering Faculty, USTO-MB Oran, El- M’Naouar, Oran, Algeria

M. Younsi |
Mining and Metallurgy Department, Mechanical Engineering Faculty, USTO-MB Oran, El M’naouar, Oran, Algeria

نشانی اینترنتی https://www.ije.ir/article_141882_93facacde1dd8b87f05a4b4c0703a11d.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات