این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Energy Equipment and Systems، جلد ۱۰، شماره ۲، صفحات ۱۹۷-۲۱۴
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Experimental investigation of the effect of single point dressing parameters on grinding of Mo40 hardened steel using mounted point grinding tool
چکیده انگلیسی مقاله Nowadays, steel hardening has received much attention from researchers due to its frequent use in industries, especially is widely used in energy equipment, aerospace, and petrochemical industries. Low capability in chip removal of hardened steel has always been a significant machining issue. Mounted point grinding is a machining method to improve surface finish and remove burrs on the workpiece walls and hard-to-reach areas. This process is usually used without preparing the grinding wheel before and during the grinding operation, which reduces the proper performance of the process. Environmental contamination, surface integrity, coolant-lubricant-related diseases that affect workers' health, and machining costs heavily depend on the appropriate dressing and proper coolant-lubricant usage. In this study, the effect of dressing conditions (depth of dressing and dressing feed) and the workpiece feed rate during the mounted point grinding of a Mo40 hardened steel in two traditional wet and Minimum Quantity Lubrication (MQL) environments has been investigated. Surface roughness and wheel loading are two significant outputs in every grinding operation. The experimental result of this study reveals an improvement in enhancing the surface roughness in a soft dressing condition. Moreover, this study aimed to achieve proper surface roughness by implementing MQL technique to significantly reduce total cutting fluid usage compared to traditional wet machining. This study observed a higher wheel loading in MQL technique than in the conventional wet grinding.
کلیدواژه‌های انگلیسی مقاله Dressing,Wheel Loading,Surface quality,Grinding,Environmentally Friendly Machining
نویسندگان مقاله Mohammadjafar Hadad |
School of Mechanical Engineering, College of Engineering, University of Tehran, P.O. Box 11155/4563, Tehran, Iran

Javad Gholampour Darzi |
School of Mechanical Engineering, College of Engineering, University of Tehran, P.O. Box 11155/4563, Tehran, Iran

Ali Mahdianikhotbesara |
School of Mechanical Engineering, College of Engineering, University of Tehran, P.O. Box 11155/4563, Tehran, Iran

Javad Makarian |
School of Mechanical Engineering, College of Engineering, University of Tehran, P.O. Box 11155/4563, Tehran, Iran

نشانی اینترنتی https://www.energyequipsys.com/article_253231_039f41d4f9d04420942c185b2421f9d5.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات