|
|
International Journal of Engineering، جلد ۳۰، شماره ۴، صفحات ۵۹۱-۵۹۶
|
|
|
| عنوان فارسی |
|
|
| چکیده فارسی مقاله |
|
|
| کلیدواژه‌های فارسی مقاله |
|
|
| عنوان انگلیسی |
Optimum Swept Angle Estimation based on the Specific Cutting Energy in Milling AISI 1045 Steel Alloy |
|
| چکیده انگلیسی مقاله |
Mechanical machining processes are common manufacturing strategies to re-shape materials to desired specification. The mechanistic approach has revealed the mechanics of the machining processes with various parameters determined. The aim of this work is to investigate the impact of swept angle optimization and their influence on the specific cutting energy in milling AISI 1045 steel alloy. This is achieved by varying the step over at different feed rate values in order to determine the optimization criterion for machining. It was observed that an optimum swept angle of 31.8o was appropriate in the elimination of ploughing effect and reducing the specific cutting energy to an optimised minimum value. However, higher swept angle of 41.4o increases the specific cutting energy with a higher machine tool power. This is attributable to the reduction in the cycle time caused by shorter toolpath length. The results obtained further elucidate the knowledge base for the determinations of optimum parameters for sustainable machining and resource efficiency of manufactured products. |
|
| کلیدواژه‌های انگلیسی مقاله |
|
|
| نویسندگان مقاله |
Isuamfon F. Edem |
, Akwa Ibom State University, Mkpat Enin, Akwa Ibom
Vincent Balogun |
Mechanical Engineering, Edo University Iyamho, Auchi, Edo State, Nigeria
|
|
| نشانی اینترنتی |
http://www.ije.ir/article_72924_5d984cf1ecf3c165bfb9e0437636d74a.pdf |
| فایل مقاله |
اشکال در دسترسی به فایل - ./files/site1/rds_journals/409/article-409-2062123.pdf |
| کد مقاله (doi) |
|
| زبان مقاله منتشر شده |
en |
| موضوعات مقاله منتشر شده |
|
| نوع مقاله منتشر شده |
|
|
|
|
برگشت به:
صفحه اول پایگاه |
نسخه مرتبط |
نشریه مرتبط |
فهرست نشریات
|